Xtramus NuTAP-S61 V1.2 Bedienungsanleitung PDF herunterladen (Seite 67)

XTRAMUS TECHNOLOGIES

You can configure filterin the Port Config –

Monitor Port screen.

.6. Monitor Port Setting

g/capture criteria and pattern check for Monitor Port M0/M1 in

There are two ways to access Port Config – Monitor Port:

Accessing Port Config – Monitor Port

• Click Monitor Port M0/M1

in the Menu Bar.

located on Config

• Click the Monitor Port M0/M1

on Quick Launch Buttons

button located

Port Config – Monitor Port M0/M1

The Monitor Port to set the hea would like to add to packets

P s Stamp,

VLAN TAG, IP Header, UDP Header, and IP Fragment s are corresponding with the value

setting page allows you ders that you

transmitted from Monitor Port M0/M1. NuSet-MiniTA upports headers including DA/SA, Time

. These header

inputting field down below the Monitor Port setting pag as show in the table here:

¾ DA/SA: Destination/Source MAC Address.

amp

SIP (Source IP Address).

Fragment: MTU (Maximum Transmission

¾ Time Stamp: N/A. However, a timest

header will be added to the packets.

¾ VLAN TAG: VID (VLAN ID).

¾ UDP Header: DPort (Destination Port) and

SPort (Source Port).

¾ IP

¾ IP Header: DIP (Destination IP Address) a

Unit)

Button

Apply

on this page, you must click the Apply button or all changes will be lost.

: Apply and save the changes you’ve made on this page. After making any settings

Website: www.Xtramus.com

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 73 74 75

Keine Kommentare

Xtramus NuTAP-S61 V1.2 Bedienungsanleitung Seite 67