Xtramus APMPT-4 V2.4 Bedienungsanleitung PDF herunterladen (Seite 101)

101

E-mail: sales@xtramus.com

Website: www.Xtramus.com

XTRAMUS TECHNOLOGIES

5.5. Test Task – AC

Test Task – AC allows you to test DUT‟s power supply. For more detail description regarding to Test

Task – AC, please refer to “1.3.5. AC Test”. Please note that if you don‟t have XM-2WL1 module card

installed on your chassis, you can‟t run tasks mentioned here.

5.5.1. PWR-Setup (Power Setup Test)

With module card XM-2WL1 providing power to the DUT, you can perform power ON/OFF and cycling

tests with PWR-Setup.

Setup

 Power Control: To turn the power of DUT ON or OFF.

 Zero/Peak Cross: In a Voltage vs. Time diagram shown on the

right, a Zero Cross happens every time when the value of

voltage reaches zero. Zero-crossing is the key to determining

the proper switching time (phase angle) in both leading edge

and trailing edge dimmers. You can set the crossing mode to 0

to 270 degrees here, or you can set the crossing mode to

Free-run mode.

 Cycle Setting: By click the Enable Cycle Reboot check-box, you can perform power on/off

cycling tests.

 Initial/End: You can set the starting/ending power status to ON/OFF here in these fields.

 Count: You can set how many times you would like to run the power on/off cycling test.

 Interval: You can set the amount of seconds system shall wait between each cycling test.

 Wait before Power ON/OFF: System will halt for the set amount of seconds before power on/off.

 Wait after Power ON/OFF: System will halt for the set amount of seconds after power on/off.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 144 145

Keine Kommentare

Xtramus APMPT-4 V2.4 Bedienungsanleitung Seite 101